Permanent Anti-Slip Road Marking Tapes
01
Preformed Permanent anti-slip marking tapes (Particles Surface)
Product Information
Brand： Color Road
Colors: red, yellow, white, blue, black, green
Product Features
--The base material of the preformed material is composed of polymer flexible polymer rubber, fillers, pigments, etc., and a layer of high wear-resistant environmental protection coating and anti-skid particles are planted on the surface. It has anti-skid, strong wear resistance, good weather resistance, and long durability, The construction is convenient and fast. Widely used in railway stations, bus stations, shopping malls, hotels, hotels, hospitals, schools, and other outdoor markings, signs, patterns, etc.
Scope of application
--Suitable for rubber products, concrete, asphalt, cement, marble, epoxy floor, ceramic tile, etc., basically suitable for the bonding of various floors, this product is recommended for outdoor use and requires various floor effects of B-level or above non-slip best. The main advantage is that it is non-slip, and the disadvantage is that it is not resistant to dirt. It can be made into various marking lines, arrows, characters, patterns, color signs, logos, color three-dimensional signs, etc. According to the condition of the road surface, the flow of people, and the installation situation, the service life can reach at least 3 years.
Technical Indicators
|
Properties |
Typical data |
Unit |
Test Methods |
|
|
Color |
white |
yellow |
________ |
________ |
|
Thickness |
1.5-1.6 |
1.5-1.6 |
mm |
GB/T 7125 |
|
Water resistance |
pass |
pass |
________ |
GB/ T24717 |
|
Acid resistance |
pass |
pass |
________ |
GB/T 24717 |
|
Wear-resistant |
50 |
50 |
mg |
GB/T24717 |
|
Minimum adhesion |
25 |
25 |
N/25mm |
GB/T24717 |
|
Anti-skid value |
＞60 |
＞60 |
BPN |
GB/T24717 |
Instructions
1. The pavement marking tape without adhesive backing is commonly used in special environments and special materials, using special glue, such as two-component AB glue, 502 glue, etc.
2. The products with adhesive backing can be divided into ground brush primer and ground primer without brush according to the usage:
Without brush primer on the ground: It can be directly applied to smooth and flat surfaces without applying primer when used indoors, on outer pavement, and on various walls of place such as workshops, exhibition halls, squares, safety islands of toll stations, where few vehicles run over, it only needs rip off the isolated paper on the back of the product and sticks it directly to the joint surface. And its life can be 5 years to the longest.
Brush primer on the ground: It should be applied with primer on uneven surfaces or walls(e.g., Pattex Contact Adhesive, Maxbond UL 1603HFR-HS). The amount of primer required depends on the smoothness of the bonding surface, approximately 1 kilogram per 3 to 5 square meters. Please refer to the construction instructions when using the primer.
description2